Today i’m sharing with you a powerful networking design and analysis software named Cisco Packet Tracer 6.1.1. Though it is an old version now because a new version of Packet Tracer 7.1 is already available online. I share it because if you feel interest to work in these version then you must needed to download it from internet.
Cisco Packet Tracer 7.3 has been released ! Current build is Packet Tracer 7.3.0.0838. Have a look at Cisco Packet Tracer 7.3 new features General improvements in Cisco Packet Tracer 6.1.1
Cisco Packet Tracer 6.1 (version 6.1.0.0120) has been available on netacad since July 2014 for Cisco Networking Academy members. A newer verion, Packet Tracer 6.1.1 has been released at the end of august. This is a minor release correcting bugs found in the previous 6.1.0.0120 version. Packet Tracer 6.1.1 includes the following new or improved features :
Server (end-device) new services / applications :
IPv6 Routing protocols enhancements :
DHCP new features :
Switches :
Simulation / Activity Wizard:
Port channel support has also been improved in Packet Tracer 6.1.1 with layer 3 etherchannel support on ISR routers.
Packet Tracer 6.1.1 is fully supported on Windows 7 and Windows 8 or 8.1. Support for Windows Vista has been stopped by Cisco in this new version.
New Hardware in Cisco Packet Tracer 6.1.1
Download sims for mac free. Cisco Packet Tracer 6.1.1 includes a major capacity improvement with the introduction of a new Security device class including an ASA 5505 firewall. By default, the Eth0/0 interface is configured in the outside vlan (vlan 2) and the Eth0/1 to Eth0/7 interfaces in the inside vlan (vlan 1).
Features & limitations compared to the real ASA 5505:
New vlans can be created using the config tab or the cli command 'interface vlan X'. However, the licence included in the ASA doesn't allow configuring more than two vlan with nameif (This license does not allow configuring more than 2 interfaces with nameif and without a 'no forward' command on this interface or on 1 interface(s) with nameif already configured).
https://ddauin.weebly.com/blog/foscam-ip-viewer-will-not-download-mac. Another limitation is on the physical interfaces which can only be configured in access mode. The command 'switchport mode trunk' documented in the ASA configuration guide has not been implemented on the simulated ASA 5505 in Packet Tracer 6.1 .
IPSEC tunnels and clientless SSL VPN are supported on ASA 5505 but VTI interfaces or GRE tunnels are not available on this firewall. GRE tunnels have to be terminated on an inside ISR edge router.
Packet Tracer For Mac DownloadNew IOS version (IOS 15) for catalyst 2960 switch :
A new IOS 15 c2960-lanbasek9-mz.150-2.SE4.bin image is available for the catalyst 2960 switch. The image is not installed by default on the switch and has to be downloaded from a TFTP server (server end device) using the following procedure :
Switch#copy tftp: flash:
Address or name of remote host []? 192.168.1.2 Source filename []? c2960-lanbasek9-mz.150-2.SE4.bin Destination filename [c2960-lanbasek9-mz.150-2.SE4.bin]?
Accessing tftp://192.168.1.2/c2960-lanbasek9-mz.150-2.SE4.bin..
Loading c2960-lanbasek9-mz.150-2.SE4.bin from 192.168.1.2: !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! [OK - 4670455 bytes]
4670455 bytes copied in 0.054 secs (6953476 bytes/sec)
Switch#dir Directory of flash:/
1 -rw- 4414921 <no date> c2960-lanbase-mz.122-25.FX.bin
2 -rw- 4670455 <no date> c2960-lanbasek9-mz.150-2.SE4.bin Adobe photoshop 2017 torrent download. Packet Tracer 6.1.1 Download Mac Installer
Download mental ray for maya 2018 mac. 64016384 bytes total (54931008 bytes free)
Switch#conf t Enter configuration commands, one per line. End with CNTL/Z. Switch(config)#boot system c2960-lanbasek9-mz.150-2.SE4.bin Switch(config)#exit Switch# %SYS-5-CONFIG_I: Configured from console by console Switch#copy running-config startup-config Destination filename [startup-config]? Building configuration.. [OK]
Switch#reload
Download Packet Tracer 6 3Netflow
Netflow is a network analysis protocol that was initially created by Cisco to give the ability to collect network traffic as it flows through a router interface. The data processed by Netflow collectors provides the network administrator with detailled traffic informations such as the source and destination of the traffic, class of service, .. Netflow version 9 was standardized in 2008 as IPFIX by the IETF organization.
The following Netflow components are available in Packet Tracer 6.1.1 :
Packet Tracer 6.1.1 Download Mac Pc
Reviewed by PacketTracerNetwork on - Rating : 5
Comments are closed.
|
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2020
Categories |